- Turn the Wii console power OFF by pressing the POWER Button on the front of the console. Unplug the power cord from the wall outlet for a few seconds. After a few seconds have elapsed, plug the cord back into the wall outlet.
- Turn the power of the Wii console ON. When you see the Health and Safety screen, open the small flap on the front of the Wii console to find a red button labeled "SYNC." Press and hold the SYNC Button down for 15 seconds. This will clear all the syncs on the Wii, allowing you to get a clean start to begin the process described below.
- After holding the SYNC Button on the Wii console down for at least 15 seconds, you can now "re-sync" your Wii Remotes:
- With the first Wii Remote you wish to sync, remove the battery cover on the back of the Wii Remote to find a small red button just below the batteries.
- Press and release the small red button just below the batteries on the Wii Remote; the blue lights on the front of the Wii Remote will blink.
- Quickly press and release the red SYNC button on the inside of the white flap on the front of the Wii console (picture).
- When the Player LED blinking stops and stays lit, the syncing is complete. The LED that is illuminated indicates the player number (1 through 4).
- This sync procedure (steps "a" through "d" above) must be followed for each additional Wii Remote added to the system.
Howdy,
Since this is Saturday, I am troubleshooting kids/family electronics today. For some reason our Wii would not cooperate. It was not recognizing the remotes. I think it had something to do with Wii Fit being installed recently. So, after some Googling, I found these steps. I hope this will get you out of a jam.
No comments:
Post a Comment